Motor Operation Check Mode; Entering The Motor Operation Check Mode; List Of Motor Operation Check States - Canon Staple Finisher-H1 Service Manual

Table of Contents

Advertisement

5
Adjustment > Dip Switch Function > Motor Operation Check Mode > List of Motor Operation Check States

Motor Operation Check Mode

■ Entering the Motor Operation Check Mode

(1) With the host machine turned off, set the DIP switch (SW1) as shown below. While pressing down the push switch (SW2), turn on the host machine.

■ List of Motor Operation Check States

By setting the DIP switch (SW1) according to the following table after entering the motor operation check mode, you can check the operation of each motor.
No.
DIP Switch (SW1) Setting
1
2
3
4
1
ON
OFF
OFF
OFF
2
OFF
ON
OFF
OFF
3
ON
OFF
ON
OFF
4
ON
ON
OFF
OFF
5
OFF
OFF
ON
OFF
6
OFF
ON
ON
OFF
7
ON
ON
ON
OFF
8
OFF
OFF
OFF
ON
9
ON
OFF
OFF
ON
5
Adjustment > Dip Switch Function > Motor Operation Check Mode > List of Motor Operation Check States
Name
Feed Motor (M1)
Pressing down the push switch (SW2) each time drives the feed motor with the feed speed changed as follows:
Feed speed 311 mm/sec → Feed speed 137mm/sec → Stop
Delivery Motor (M2)
Pressing down the push switch (SW2) each time drives the delivery motor with the feed speed changed as follows:
Feed speed 311mm/sec → Feed speed 700mm/sec → Feed speed 137mm/sec → Feed speed 250mm/sec → Stop
Paddle Motor (M3)
Pressing down the push switch (SW2) drives the paddle motor to rotate the paddle once.
Front Alignment Motor (M4)
Pressing down the push switch (SW2) each time drives the front alignment motor to move the front alignment plate
as follows:
Minimum-width paper alignment position → Maximum-width paper alignment position
Rear Alignment Motor (M5)
Pressing down the push switch (SW2) each time drives the rear alignment motor to move the rear alignment plate
as follows:
Minimum-width paper alignment position → Maximum-width paper alignment position
Tray Auxiliary Guide Motor (M6)
Pressing down the push switch (SW2) each time drives the tray auxiliary guide motor to move the tray auxiliary
guides as follows:
Support position → Home position (retracted position)
Gripper Motor (M7)
Pressing down the push switch (SW2) drives the gripper motor to operate the gripper by one cycle.
Stack Tray Shift Motor (M8)
Pressing down the push switch (SW2) each time drives the stack tray shift motor to move the stack tray as follows:
Stack tray lower limit position → Stack position
Staple Motor (M9)
Pressing down the push switch (SW2) drives the staple motor to operate the stapler by one cycle.
ON
1
2 3 4
F-5-3
Operation
5-4
T-5-2
5-4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents