Download Print this page

Canon Staple Finisher-H1 Service Manual page 23

Hide thumbs

Advertisement

2
Technology > Processing Tray Unit > Alignment / Shifting Operation
The relationship between operation modes and alignment positions is summarized in the
following table:
Operation Mode
Paper Width
Non-Sort / Sort
180 mm or more
less than 180 mm
Staple
200 mm or more
less than 200 mm
2
Technology > Processing Tray Unit > Alignment / Shifting Operation
Alignment Position
• Front alignment position: 10 mm frontward
from the central reference position
• Rear alignment position: 10 mm backward
from the central reference position
Central reference position
Stapling position
10 mm frontward from the central reference
position
The relationship between operation modes and shifting positions is summarized in the
following table:
Operation Mode
Paper Width
Non-Sort / Sort
210 mm or
more
180 mm or
more to less
than 210 mm
T-2-5
less than 180
mm
Staple
210 mm or
more
less than 210
mm
NOTE:
In the non-sort mode, paper is aligned/shifted at the position which is different from the
position where paper was aligned/shifted at the end of the previous copy job.
Shifting Position
• Front shift position: 10 mm frontward from the central
reference position (Same as the alignment position)
• Rear shift position 10 mm backward from the central
reference position (Same as the alignment position)
*: Shift amount: 20 mm
• Front shift position: F mm frontward from the central
reference position
F = 110 - ("Paper width" / 2)
• Rear shift position: R mm frontward from the central
reference position
R = 85 - ("Paper width" / 2)
*: Shift amount: 25 mm
• Front shift position: 10 mm frontward from the central
reference position
• Rear shift position: 10 mm backward from the central
reference position
*: Shift amount: 20 mm
• Front shift position: 10 mm frontward from the central
reference position
• Rear shift position: 10 mm backward from the central
reference position
*: Shift amount: 20 mm
• Front shift position: F mm frontward from the central
reference position
F = 110 - ("Paper width" / 2)
• Rear shift position: R mm frontward from the central
reference position
R = 85 - ("Paper width" / 2)
*: Shift amount: 25 mm
2-11
T-2-6
2-11

Hide quick links:

Advertisement

loading