Removing The Stack Tray Shift Motor (M8) - Canon Staple Finisher-H1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Stack Tray Shift Motor (M8)

Removing the Stack Tray Shift Motor (M8)

1) Remove the rear cover.
CAUTION:
(Refer to page 4-7)
As the stack tray lowers by removing the gear, carry out the work
while supporting the stack tray.
3) Remove the 3 screws and disconnect the connector, and then remove the stack tray shift motor along
with the support plate.
x3
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Stack Tray Shift Motor (M8)
F-4-44
4) Remove the 2 screws, and then remove the stack tray shift motor.
x1
F-4-46
2) Removing the E-ring and gear and straight pin.
x2
4-21
F-4-45
F-4-47
4-21