Alignment / Shifting Operation - Canon Staple Finisher-H1 Service Manual

Hide thumbs

Advertisement

Table of Contents
2
Technology > Processing Tray Unit > Alignment / Shifting Operation
The tray auxiliary guide slide-out amount varies depending on the operation mode and paper
length as follows:
Operation Mode
Paper Length
Amount of Slide Out
Non-Sort / Sort
150 mm or more to less than
55 mm
217 mm
217 mm or more to less than
55 + ("Paper Length" - 216) mm
300 mm
300 mm or more
120 mm
Staple
150 mm or more to less than
50 mm
217 mm
217 mm or more
55 + ("Paper Length" - 216) mm
T-2-4
2
2-10

Alignment / Shifting Operation

The paper stacked on the processing tray is aligned in the width direction by the front and
rear alignment plates. Then, the paper is shifted to the position where it is delivered to the
stack tray.
The front alignment plate is driven by the front alignment motor (M4) and the rear alignment
plate is driven by the rear alignment motor (M5). The home positions of the front and rear
alignment plates are detected by the front alignment plate HP sensor (S4) and rear alignment
plate HP sensor (S5).
Front Alignment Plate
Rear Alignment Plate
Front Alignment Plate
HP Sensor (S4)
Rear Alignment Plate
Front Alignment Motor (M4)
HP Sensor (S5)
Rear Alignment Motor (M5)
F-2-15
2-10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents