Canon Staple Finisher-H1 Service Manual page 51

Table of Contents

Advertisement

4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Upper Processing Tray Unit (Front / Rear)
7) Remove the 4 screws, and then remove the support plate.
x4
9) Remove the 5 screws and disconnect the connector, and remove the belt by
loosening the 2 screws [A] securing the delivery motor unit, and then remove the
delivery unit.
A
4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Upper Processing Tray Unit (Front / Rear)
8) Remove the 4 screws, and then remove the delivery guide.
x4
F-4-24
CAUTION:
x5
x1
A
F-4-26
F-4-25
When tightening the screws securing the delivery motor unit, attach the belt and then tighten
them at the position where tension is applied to the belt due to the motor's own weight.
4-13
F-4-27
4-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents