Canon Staple Finisher-H1 Service Manual page 24

2
Technology > Processing Tray Unit > Alignment / Shifting Operation
● Alignment Operation in Non-sort / Sort Mode
(1) After lapse of the specified time since detection of paper by the delivery sensor (S2), the
front and rear alignment plates move to the standby position (paper width + 10 mm).
Rear Alignment Plate
Half of Paper Width
+10mm
Middle of Feeding Path
Half of Paper Width
+10mm
Front Alignment Plate
2 Technology > Processing Tray Unit > Alignment / Shifting Operation
(2) After lapse of the specified time since detection of the trailing edge of paper by the
delivery sensor (S2), the front and rear alignment plates move for paper alignment.
• Front / Rear alignment position (when the paper width is 180 mm or more)
F-2-16
• Alignment position of central reference (when the paper width is less than 180 mm)
Paper (when aligning in the rear)
Rear Alignment Position
20mm
20mm
Front Alignment Position
Paper (when aligning in the front)
10mm
Middle of Feeding Path
10mm
2-12
F-2-17
Paper
F-2-18
2-12