Removing The Delivery Motor (M2) - Canon Staple Finisher-H1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Delivery Motor (M2)

Removing the Delivery Motor (M2)

1) Remove the rear cover. 2) Remove the E-ring and spring and screw, and then remove the hook and lever.
(Refer to page 4-7)
3) Remove the 2 screws and belt, and then disconnect the connector to remove the delivery motor.
x2
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Delivery Motor (M2)
x1
F-4-34
x1
F-4-35
CAUTION:
When attaching the delivery motor, attach the belt with the screws tightened loosely
and then tighten the screws securely at the position where tension is applied to the
belt due to the motor's own weight.
4-17
F-4-36
4-17