Ccd Lock Rap - Xerox phaser 3635 Service Manual

14-100 CCD Lock RAP

14-100 The machine has detected a mechanical fault with the CCD module.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Refer to Wiring Diagram 3. Perform the following:
1. Raise the DADF. Check that the scanner lock, PL 14.10 Item 22 is completely unlocked.
2. Remove the scanner cover, PL 14.10 Item 20.
3. Check that the CCD module, PL 14.10 Item 8 moves freely from left to right.
4. Check the wiring between the CCD home sensor and CN5 on the Main PWB. If neces-
sary, install a new CCD home sensor, PL 14.10 Item 4.
5. Check the wiring between the scan motor, PL 14.10 Item 10 and CN4 on the Main PWB.
6. If necessary:
a. Install new components:
• Scanner motor drive assembly, PL 14.10 Item 6.
• CCD module, PL 14.10 Item 8.
• Scanner assembly, PL 14.10 Item 26.
b. Perform OF7 Main PWB Check RAP.
Draft 4
Phaser 3635MFP 2-33
Status Indicator RAPs
14-100