Xerox phaser 3635 Service Manual page 105

Table 1 NVM location
Mode Tray Location
Duplex Side 1 Bypass 07-520
Duplex Side 2 1 07-120
Duplex Side 2 2 07-220
6. Select Read/Write. Enter a new value as follows:
• To increase the lead edge registration (move the ABC line away from the paper
edge), enter a value larger than the current value.
• To decrease the lead edge registration (move the ABC line toward the paper edge),
enter a value smaller than the current value.
NOTE: A change of 12 will change the registration by approximately 1mm (0.04
inch)
7. Save the adjustment.
a. Select Save.
b. Select OK.
8. Prepare to check the adjustment.
a. Select Close.
b. Select Diagnostic Routines.
c. Select Other Routines.
9. Perform again the Check.
Repairs and Adjustments
ADJ 8.1, ADJ 8.2
ADJ 8.2 Side Edge Registration Adjustment
Purpose
To measure and adjust side edge image to paper registration.
Check
NOTE: Both the Check and the Adjustment use an internal test pattern. Both are performed in
diagnostics.
Check the side edge registration (left side edge of portrait A4 or 8.5x11 inch). Perform the fol-
lowing:
1. Enter dC606 Internal Print Test Patterns.
2. Select test pattern 7.
3. Select Features. For simplex side edge check, select 1 Sided. For duplex side edge
check select, 2 Sided.
4. Select the tray. Select Start Test.
NOTE: Simplex copies exit face down. Duplex copies exit side 1 face down (side 2 face
up).
4-50
Draft 4
Phaser 3635MFP