Rep 5.3 Dadf Registration And Scan Sensors - Xerox phaser 3635 Service Manual

Replacement
WARNING
Ensure all ground leads are connected.
1. Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 5.2, REP 5.3

REP 5.3 DADF Registration and Scan Sensors

Parts List on PL 5.35
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the DADF, PL 5.10 Item 1.
2. Remove the DADF rear cover, PL 5.10 Item 9.
3. Remove the DADF door assembly, PL 5.10 Item 3.
4. Release the DADF feed assembly, PL 5.10 Item 4.
NOTE: It is not necessary to disconnect the harness from the DADF feed assembly.
5. Remove the DADF transport assembly upper cover, PL 5.35 Item 13.
6. Remove the DADF registration sensor or scan sensor as necessary, Figure 1.
DADF scan sensor
DADF registration sensor
Figure 1 Sensor location
Replacement
1. Replacement is the reverse of the removal procedure.
4-14
WARNING
CAUTION
Phaser 3635MFP
Draft 4