Xerox phaser 3635 Service Manual page 106

5. Measure the distance between the lead edge of the paper and the ADG line on the printed
test pattern, Figure 1.
Figure 1 Test pattern 7
6. If the distance measured is not 12.7mm (0.5 inch) +/-3mm (1/8 inch), perform the Adjust-
ment.
Adjustment
1. Select Exit (on the dC606 Internal Print Test Patterns screen).
2. Select Diagnostic Routines.
3. Select Copier Routines.
4. Select 131 NVM Read Write.
5. Refer to Table 1. Select the relevant NVM setting.
Table 1 NVM location
Mode Tray Location
Simplex 1 07-110
Simplex 2 07-210
Simplex Bypass 07-510
Draft 4
Phaser 3635MFP
Table 1 NVM location
Mode Tray
Duplex Side 1 1
Duplex Side 1 2
Duplex Side 1 Bypass
Duplex Side 2 1
Duplex Side 2 2
6. Select Read/Write. Enter a new value as follows:
• To increase the side edge registration (move the ADG line away from the paper
edge), enter a value larger than the current value.
• To decrease the side edge registration (move the ADG line toward the paper edge),
enter a value smaller than the current value.
NOTE: A change of 12 will change the registration by approximately 1mm (0.04
inch)
7. Save the adjustment.
a. Select Save.
b. Select OK.
8. Prepare to check the adjustment.
a. Select Close.
b. Select Diagnostic Routines.
c. Select Other Routines.
9. Perform again the Check.
4-51
Location
07-150
07-250
07-550
07-130
07-230
Repairs and Adjustments
ADJ 8.2