Xerox phaser 3635 Service Manual page 97

REP 14.2 Scanner Components
Parts List on PL 14.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the DADF, PL 5.10 Item 1.
2. Remove the UI assembly, REP 2.1.
CAUTION
Do not allow the optics cavity to become contaminated. Contamination of the optics cavity can
cause image quality defects.
3. Remove the scanner cover, Figure 1.
Figure 1 Scanner cover removal
4. If necessary, remove the CCD home sensor or the platen cover sensor, Figure 2.
Repairs and Adjustments
REP 14.2
1
Remove 4 screws.
2
Release 3 clips at each side, then
remove the scanner cover.
Figure 2 Sensor locations
5. If necessary, remove the CCD module, Figure 3.
4-38
Platen cover sensor
CCD home sensor
Draft 4
Phaser 3635MFP