Xerox phaser 3635 Service Manual page 100

REP 28.2 Outbin Assembly
Parts List on PL 28.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the DADF, PL 5.10 Item 1.
2. Remove the UI assembly, REP 2.1.
3. Remove the left cover, right cover and rear cover, REP 28.1.
4. Remove the scanner assembly, REP 14.1.
5. Remove the stapler assembly, PL 11.10 Item 4.
6. Disconnect the following harnesses from the Connection PWB:
• CN7
• CN1
• CN2
7. Remove the exit cover assembly, PL 28.10 Item 2.
8. Disconnect the following harnesses from the Main PWB:
• CN7
• CN14
• CN15
• CN26
9. Prepare to remove the outbin assembly, Figure 1.
Repairs and Adjustments
REP 28.2
Main PWB location spigot
Figure 1 Preparation
Take care not to damage the main PWB location spigot when removing the outbin, refer to Fig-
ure 1. Also, take care not to move the exit roll and idlers.
10. Remove the outbin assembly, Figure 2.
4-42
1
Remove 6 screws marked A.
CAUTION
Phaser 3635MFP
Draft 4