ADJ 5.1 DADF Side Edge Registration Adjustment
Purpose
To correctly set the DADF side edge registration.
Procedure
Perform the following:
1.
Remove the input tray assembly, PL 5.15 Item 2.
2.
Remove the lower cover, PL 5.15 Item 1.
3.
Carefully move both document guides to the front or the rear to adjust the registration.
NOTE: Moving both document guides 1 tooth on the pinion gear will adjust the registra-
tion by approximately 3mm (0.1 inch).
4.
Assemble the input tray assembly.
5.
Use the DADF to make 10 copies of a document. Check the registration, refer to IQS 3
Registration. If necessary, re-adjust the registration.
Draft 4
Phaser 3635MFP
4-47
Repairs and Adjustments
ADJ 5.1