Configure Pptp Client For A Remote Vpn Server - HP MSM7xx Management And Configuration Manual

Working with VPNs
Securing controller communications to remote VPN servers
Note the selections made in the sample Add/Edit security policy page above.
Option
General
Name
Phase 1 mode
Mode
Interface
Encryption
algorithm
Perfect Forward
Secrecy
Accept any peer
Peer information
Authentication
method
Security policy >
Only permit
incoming...
Only permit
outgoing...
See the online help for option descriptions.
See

Configure PPTP client for a remote VPN server

Configure the PPTP client for the controller VPN client capability via the Controller >> VPN
> PPTP client menu.
The PPTP client enables the controller to create a secure tunnel to any device that provides a
PPTP server. All traffic sent though this tunnel is protected against eavesdropping by means
of encryption.
16-8
Value to set
Enabled
user-defined
Main mode
Tunnel
Internet port
Select as desired
Leave enabled
Disabled
User-defined
User-defined
Identify the subnet Identify the local subnet for which you wish to
Identify the remote
subnet
Keeping user traffic out of the VPN tunnel on page
Notes
Set according to VPN server needs. In this
example, the VPN server address is 3.1.1.1.
Set according to VPN server needs. Either the
X.509 certificates or the Preshared key must
match server configuration.
filter traffic, for example, 7.1.1.0. This must
match the value defined in the policy on the
peer (VPN server).
Identify the remote subnet for which you wish
to filter traffic, for example, 10.0.0.0. This must
match the value defined in the policy on the
peer (VPN server).
16-10.