HP MSM7xx Management And Configuration Manual page 229

2. Select Add New VLAN. The Add/Edit VLAN page opens.
3. Under General, select the port to which the VLAN will be bound. Once a VLAN has been
defined on a port, the port assignment cannot be changed. To assign the VLAN to a
different port, delete the VLAN definition and create a new one on the required port.
4. Under VLAN, select the VLAN ID to assign. The list contains all network profiles that are
defined with a VLAN ID or range.
5. Specify how the VLAN obtains an IP address.
An IP address cannot be assigned to a VLAN range.
 DHCP client: The VLAN obtains its IP address from a DHCP server on the same
VLAN. Note: There is no support for obtaining a default gateway from the DHCP
server.
 Static: Enables you to manually assign an IP address to the VLAN. If you select this
option, you must specify a static IP address, Mask, and Gateway.
 None: Specifies that this VLAN has no IP address, so that you can use the VLAN for a
VSC ingress mapping.
6. Enable NAT support if required. (Available only if addressing is DHCP client or Static.)
By default NAT is disabled. See
7. Select Save.
Network address translation (NAT) on page
Working with VLANs
Defining a VLAN
3-30.
7-5