User authentication, accounts, and addressing
(Only available when Access control is disabled under Global)
Select the value that the AP (with which the user has established a wireless connection) will
return as the called station ID.
Port 1: MAC address of the first Ethernet port on the AP.
Port 2: MAC address of the second Ethernet port on the AP. (Not supported on all APs.)
Wireless Radio: MAC address of the wireless radio on the AP on which this VSC is
BSSID: Basic service set ID of the wireless network defined for this VSC.
macaddress:ssid: The MAC address of the AP radio, followed by a colon, followed by
the SSID configured on this VSC.
Configuring global 802.1X settings for wired users
Global 802.1X settings selecting Controller >> Authentication > 802.1X.
These settings only apply to:
Wired clients connected to the service controller via the LAN port.
Wireless clients using an access-controlled VSC with Wireless protection set to WPA
and the Terminate WPA at the controller option enabled. See
controller on page
These settings do not apply to clients connected to the switch port on an MSM317.
Specify the maximum length of time that the service controller will wait for a client station to
respond to an EAPOL packet before resending it.
If client stations are configured to manually enter the 802.1X username and/or the password,
you must increase the value of the timeout to between 15 and 20 seconds.
Terminate WPA at the