Configuring Mobility Traffic Manager; Defining The Mobility Domain - HP MSM7xx Management And Configuration Manual

Configuring Mobility Traffic Manager

MTM configuration can be separated into the following tasks:
 Define the mobility domain.
 Define network profiles.
 Assign home networks to users.
 Define local networks on controllers and APs.
 Configure mobility settings for each VSC. (The same VSCs must be defined on all
controllers in the mobility domain, even on controllers that are not managing any
APs.)
 Bind VSCs to the APs.
Each task is described in more detail in the sections that follow.

Defining the mobility domain

When MTM will be used on more than one controller, or with a controller team, you must
define a mobility domain. The following instructions apply to non-teamed controllers. If you
are working with a controller team, see
Connect to the management tool on the controller that will be the primary mobility
controller, and do the following:
1. Select Controller >> Management > Device discovery.
Select Mobility controller discovery.

 Select This is the primary mobility controller.
2. Select Save.
Mobility support on page
Mobility traffic manager

Configuring Mobility Traffic Manager

8-26.
9-9