HP MSM7xx Management And Configuration Manual page 586

sFlow
Configuring and activating sFlow
Important
Under normal conditions, sFlow settings on the controller will be configured by an sFlow
collector operating elsewhere on the network. Therefore, in most cases all you need to do to
support sFlow is select the Enabled option under Global settings.
Advanced users who want to fine tune their sFlow configuration, or who are using an sFlow
collector in manual mode, can select Advanced Configuration to gain access to additional
settings.
Manual configuration of sFlow will not work with PCM, and other collectors may require
special configuration to operate in this manner.
Global settings
Enabled
Turns sFlow support on. Once enabled, sFlow agents will be activated on all controlled APs,
and the agents will appear in the Active sFlow agents list. To see this list, select Advanced
Communication.
Disabled
Turns sFlow support off.
Advanced communication
Select this button to define advanced sFlow configuration settings.
MIB version
Version number of the supported sFlow-MIB.
Management address
This is the IP address that a collector will use to configure sFlow. It is usually the LAN port IP
address.
Note
SNMP must be enabled on this port hosting the management address.
sFlow enabled interfaces
Displays the number of sFlow interfaces that are enabled.
To enable an interface, select Advanced Configuration.
18-4