Configuring The Mobility Settings For A Vsc - HP MSM7xx Management And Configuration Manual

Mobility traffic manager
Configuring Mobility Traffic Manager


Note
This Subnets feature has been deprecated. See

Configuring the mobility settings for a VSC

Once all home and local networks have been assigned, you can configure VSC definitions to
support MTM.
1. Select the Controller > VSCs > [VSC-name].
2. Disable the Access control option under General.
3. Select Wireless mobility, and under it, select Mobility traffic manager.
If you are using MTM to tunnel the traffic from wireless users to their home networks, set
the following parameter to determine how MTM routes traffic if no home network is
assigned to a user (via their RADIUS account or local user account), or if the user's home
network is not found in the mobility domain.
If no matching network is assigned


4. Select Save.
9-14
If a user's home network matches a local network on the AP, the user is considered to
be at home, and their traffic is bridged onto the wired network via the Ethernet port
on the AP.
If a user's home network does not match a local network on the AP, the user is
considered to be roaming, and their traffic is tunneled to appropriate home network
via the controllers that make up the mobility domain.
Block user: User access is blocked.
Consider the user at home: The user's home network is considered to be the
network assigned to the AP's Ethernet port and traffic is bridged locally by the AP.
for more information.
Subnet-based mobility