Advanced Wireless Settings - HP MSM7xx Management And Configuration Manual

 For point-to-point local mesh links on Radio 1, install two directional antennas on
connectors A and B. Installing a third directional antenna on connector C will increase
performance only on the receive side.
 Radio 2 supports diversity via its two internal antennas. but not when using an external
antenna.
Antenna gain
Supported on: MSM310. MSM310-R, MSM320, MSM320-R, E-MSM466
Not available in Monitor or Sensor modes.
For optimum performance, this parameter must be set to the gain of the antenna at the
selected frequency (DFS channel).
Max clients
Not available in Monitor or Sensor modes.
Specify the maximum number of wireless client stations that can be supported on this radio
across all VSCs.

Advanced wireless settings

Collect statistics for wireless clients
Not available in Monitor or Sensor modes.
When this option is enabled, the AP collects statistics for connected wireless client stations.
The statistical information can be retrieved via SNMP from the following MIBs:
MIB
COLUBRIS-DEVICE-WIRELESS-MIB.my
(controlled mode)
COLUBRIS-IEEE802DOT11.my
(autonomous mode)
Tx beamforming
Supported on: E-MSM430, E-MSM460, E-MSM466
Not available in Monitor or Sensor modes.
Tx beamforming can be used to help increase throughput by improving the quality of the
signal sent to wireless clients
When this option is enabled, APs use beamforming techniques to optimize the signal strength
for each individual wireless client station. Beamforming works by changing the
characteristics of the transmitter to create a focused beam that can be more optimally
received by a wireless station.
Table
coDot11DetectedStationTable
Wireless configuration
Radio configuration
4-29