Control State Monitor; Output Current (N02), Output Voltage (N03), Internal Dc Voltage (N04); Detection Frequency (N06) - Panasonic AAD03011 Instruction Manual

Control State Monitor

The following 17 items can be monitored in the control state monitor mode.
Monitor
No.
01 Output frequency
n02 Output current
03 Output voltage
04 Internal DC voltage
05 Setting frequency
06 Detection frequency
07 Door position area
08 Door position
09 OPEN arrival position data
10 No. of door switching
11 Encoder detection status
12 Fault display 1 (latest)
13 Fault display 2 (second to latest)
14 Fault display 3 (third to latest)
Fault display 4 (fourth to latest)
15
Control terminal state (input signal)
16
Control terminal state (output signal)
17

Output current (n02), output voltage (n03), internal DC voltage (n04)

The indications of the output current, output voltage and internal DC voltage are
not the accurate indications for measuring. Use those indications to get rough values.
(If you need the accurate values, use a measuring instrument.)

Detection frequency (n06)

Detects the actual speed of rotation from encoder signals.
Displays the value as detection frequency that is calculated to the frequency
from a detected speed of rotation.
Speed of rotation [r/min]
Detection frequency [Hz]
Note1) The No. of motor poles (Parameter P51) and encoder constant (Parameter
P52) should be set.
Note2) In the non-encoder mode (Parameter P09= [1, 2, 3]), the detection frequency
(n06) cannot be detected. The panel display will be "0.0".
Monitor item
No. of pulses of encoder per minute[p/min]
No. of motor poles
Indication
Output frequency(unit: Hz)
Output current (unit: A)
Output voltage (unit: V AC)
Internal DC voltage (unit: V DC)
Setting frequency (unit: Hz)
Monitor for door control
(Refer to pages 31 and 32)
Details of errors
(Refer to pages 89 and 90)
Input/output of control circuit terminals
(Refer to page 32)
Encoder constant[p/r]
Speed of rotation [r/min]
120
31