Table of Contents
Advertisement
The inverter has the following five modes.
Output frequency current display mode,
Rotation direction setting mode,
Normally, use in the output frequency current display mode. This mode is entered
when the voltage is applied.
Output frequency current display mode
[Output frequency display]
1.Output frequency
(line speed)
MODE
Frequency setting monitor mode
The frequency can be digital set ,and the
parameter P09 frequency command can
be monitored.
[Mode display]
MODE
Rotation direction setting mode
The rotation direction can be set and
the control status(local/external/
communication) can be monitored
with panel operations.
[Mode display]
MODE
Control state monitor mode
The control state and errors are monitored in
this mode.
The monitor No. is displayed when this mode
is entered.
Set the required No. with the
[Monitor No. display]
MODE
[Continued to next page]
Function of each modes
Control state monitor mode,
2.Operation preparation
status display
SET
MODE
and
buttons.
Frequency setting monitor mode,
Output current display mode
SET
The output current of the
inverter is displayed.
SET
[Data change and monitor]
SET
Change the frequency with the
and
SET button to set the data.
MODE
The parameter P09 command
frequency is displayed except
during the digital setting.
SET
[Data change]
Change the data with the and buttons,
and press the SET button to set the data.
Local -
Forward run
Note) When the parameter P08 is set to the
data other than "0", the settings cannot
be changed only with the monitor.
[Monitor]
SET
The monitor data is displayed by
pressing the SET button.
SET
(The next monitor No. will appear
when the SET button is pressed.)
The current monitor No. will appear
MODE
when the MODE button is pressed.
Function setting mode
SET
buttons, and press the
Local : L
External : E
Local -
Communication: C
Reverse run
29
- Quick Links:
- Safe Wiring
Hide quick links:
Advertisement
Table of Contents
