Maintenance, Inspection And Part Replacement - Panasonic AAD03011 Instruction Manual

Note
!
The heat sink fins and brake resistor can reach high temperatures,
so do not touch them. Doing so could lead to burns.
The inverter can be easily set to run from low speeds to high speeds.
Confirm the tolerable range of the motor and machine before starting
operation.
Failure to do so could lead to injure.
Prepare holding brakes if required.
Failure to do so could lead to injure.
If there is no arrival signal, start operation before ensuring the
security and function operation of the elevator system.
(Secure personal safety before starting operation.)
Failure to do so could lead to injury.
When carrying out the door repeat control and the door width
measurement, the operation direction of the door may change
automatically. Start operation after ensuring personal safety.
Failure to do so could lead to injury.
Adjust and confirm each parameter before operating. Depending
on the settings of the parameters, the inverter may work unexpectedly.
Failure to do so could lead to injure.

4. Maintenance, Inspection and Part Replacement

! Caution
Wait at least five minutes after turning the input power OFF before
starting inspections.
Failure to do so could lead to electric shock.
Maintenance, inspection and part replacement must be done by
qualified persons. [Remove all metal personal belongings
(watches, bracelets, etc.) before starting the work. ]
(Use tools treated with insulation.)
Failure to do so could lead to electric shocks or injury.
5