Panasonic AAD03011 Instruction Manual page 40

No.
P64
P65
P66
P67
P68
P69
P70
P71
P72
P73
P74
P75
P76
P77
P78
P79
P80
P81
Note1) The
inverter is in operation.
Note2) Parameters P53 to 58(Function cannot be used) indicate the data
is set in factory and cannot be changed.
Note3) For the communication parameters P35 to 40, always turn off the
power supply after the data has been set. The set value will be
effective after the power supply is turned on again.
38
Parameter name
OBSTACLE JUDGMENT FREQUENCY
RATIO (LOW SPEED) (%)
OBSTACLE JUDGMENT FREQUENCY
RATIO (HIGH SPEED) (%)
OBSTACLE JUDGMENT CHANGE
FREQUENCY (Hz)
OBSTACLE DETECTION
JUDGMENT TIME (ms)
START CONFIRMATION TIME (ms)
FORCED ON OPERATION
JUDGMENT TIME (s)
FAULT ON OPERATION
FORCED OPERATION TIME (s)
FAULT ON OPERATION
OPEN ARRIVAL HOLD TIME (s)
REPEAT
OPEN ARRIVAL HOLD TIME (s)
REPEAT
CLOSE ARRIVAL HOLD TIME (s)
S-SHAPED ACCELERATION/
DECELERATION FUNCTION
STOP SELECT IN OPEN/CLOSE OPERATION
NO ARRIVAL SIGNAL SELECT
SLIP ARRIVAL JUDGMENT
FREQUENCY (Hz)
SLIP ARRIVAL JUDGMENT TIME (ms)
SLIP OPEN ARRIVAL SUBSTITUTE
SELECT (s)
SAFETY SENSOR FUNTION SELECT
FAULT OPEN OPERATION FORCED
OPEN OPERATION TIME (s)
mark indicates parameters that can be changed during the
Factory
Setting range setting
data
50.0
0 100
0 100 70.0
0.5 250 5.0
0 1 999 100
100 999
200
0.0
0 0.1 500
0 0.1 500
0.0
0.0 10
0.0
0.0 10
3.0
0.0 10
3.0
0 1
0
0 1
0
0 1
0
0.1 10
1.0
1 999
100
0 0.1 10
0
0 1 0
0 0.1 500 0.0