Using Blf Feature On The Phone - Yealink SIP-T40P User Manual

User Guide for the SIP-T40P IP Phone
Click Confirm to accept the change.
3.
Note Transfer Mode on DSS Key is also applicable to BLF list feature.

Using BLF Feature on the Phone

You can use the BLF key in the following ways:
Place a call to the monitored user.

Transfer a call to the monitored user.

Pick up an incoming call of the monitored user.

Placing a Call to the Monitored User
You can press a BLF key to dial out the monitored phone number when the monitored line is
idle.
To place a call to the monitored user when the IP phone is idle:
Press the BLF key.
1.
The IP phone dials out the phone number of the monitored user.
Transferring a Call to the Monitored User
When there is already an active call on the IP phone, you can transfer the active call to the
monitored user by pressing the BLF key. The phone handles the active call differently depending
on the configuration of transfer mode via Dsskey with the BLF key (refer to
Mode on DSS Key). The transfer mode on DSS key has the following modes:
Blind Transfer

Attended Transfer

New Call

When the transfer mode on DSS key is set to Blind Transfer and there is already an active call
on the IP phone, you can do the following:
To perform a blind transfer:
Press the BLF key of the monitored user which you want to transfer this call to.
1.
Then the active call is connected to the number of the monitored user.
When the transfer mode on DSS key is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
To perform a semi-attended transfer:
Press the BLF key of the monitored user which you want to transfer this call to. The phone
1.
will dial the number of the monitored user.
126
Configuring Transfer