Attended Transfer; Call Waiting - Yealink SIP-T40P User Manual

Attended Transfer

Before performing an attended transfer (except you use dial number method), make sure that
the transfer mode on DSS key is configured as New Call or Attended Transfer. For more
information on how to configure it, refer to
123.
To perform an attended transfer:
Press the Tran soft key during a call.
1.
Do one of the following:
2.
Enter the number you want to transfer to.
-
Press
Press the Dir soft key, and then select Local Directory. Select the desired group and
-
search for the contact (Directory should be configured in advance. Refer to
on page
Press
Press the Dir soft key, and then select History. Select the desired list and then press
-
or
Directory
Press
Press the Dir soft key, and then select Remote Phone Book. Select the desired group
-
and search for the contact (Directory should be configured in advance. Refer to
Directory
Press
If Allow Trans Exist Call (refer to
-
can select the NewCall and repeat steps mentioned above to complete transfer.
After the party answers the call, press the Tran soft key to complete the transfer.
3.
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing the Cancel soft key.

Call Waiting

You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call while there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving another
call.
or to dial out.
37 for more information).
, or the Send soft key to dial out.
to select the entry (Directory should be configured in advance. Refer to
on page 37 for more information).
, or the Send soft key to dial out.
on page 37 and Remote Phone Book
, or the Send soft key to dial out.
Configuring Transfer Mode on DSS Key
on page 49
Allow Trans Exist Call on page 101) is enabled, you
Basic Call Features
on page
Directory
for more information).
105