Changing The Display Unit % To A (Ampere)/V (Volt - Toshiba TOSVERT VF-PS1 Instruction Manual

5.15

Changing the display unit % to A (ampere)/V (volt)

: Current/voltage unit selection
• Function
These parameters are used to change the unit of monitor display.
% ⇔A (ampere)/V (volt)
Current 100% = Inverter's rated current
Voltage 100% = 500Vac ( if
Example of setting
During the operation of the VFPS1-5022PM (rated current 4.1A) at the rated load (100% load), units are displayed
as follows:
1) Display in percentage terms
[Parameter setting]
Title
Current/voltage unit selection
* The converts the following parameter settings:
• A display Current monitor display
Setting of electronic thermal protection level 1/2
DC braking current
Stall prevention level
• V display Voltage monitor display
V/f 5-point setting
Note: Base frequency voltage 1, 2 (
is set in )
575Vac ( Default setting or if
690Vac ( if is set in )
Output current:
100%
DC voltage:
100%
Function
: %
: % → A (ampere)/V (volt)
, ) is always displayed in the unit of V.
E-25
is set in )
2) Display in amperes/volts
DC voltage:575V
(Converted into
＊ if
if
Adjustment range
, ,
, ,
E6581531
Output current:
4.1A
AC voltage)
was set in
was set in
Default setting
,
, ,
5