Jump Frequency - Jumping Resonant Frequencies - Toshiba TOSVERT VF-PS1 Instruction Manual

High performance inverter
Hide thumbs Also See for TOSVERT VF-PS1:
Table of Contents

Advertisement

If two signals are input simultaneously
• If a clear single and an up or down signal are input simultaneously, priority will be given to the clear signal.
• If up and down signals are input simultaneously, the frequency will be increased or reduced by the difference between
the settings of
value obtained by subtracting the setting of
Setting of the initial Up/Down frequency
To adjust the frequency start at a specified frequency other than 0.0 Hz (default initial frequency) after turning on the
inverter, specify the desired frequency using
Change of the initial Up/Down frequency
To make the inverter automatically save the frequency immediately before it is turned off and start operation at that
frequency next time power is turned on, set
setting of
when power is turned off).
Keep in mind that the setting of
Frequency adjustment range
The frequency can be set from 0.0 Hz to
set frequency clearing function (function number
Minimum unit of frequency adjustment
If
(Frequency free unit magnification) is set to
6.12

Jump frequency - jumping resonant frequencies

: Jump frequency 1
: Jumping width 1
: Jump frequency 2
: Jumping width 2
: Jump frequency 3
: Jumping width 3
• Function
Resonance due to the natural frequency of the mechanical system can be avoided by jumping the resonant
frequency during operation. During jumping, hysteresis characteristics with respect to the jump frequency
are given to the motor.
Output frequency [Hz]
Jump frequency 1 (
Jump frequency 2 (
Jump frequency 3 (
and
. For example, if the
from that of
(initial Up/Down frequency).
(change of initial Up/Down frequency) to
is changed each time power is turned off.
(Maximum frequency). The lower limit frequency will be set as soon as the
,
)
)
)
0
Frequency setting signal
F-21
setting is larger, the frequency will be increased by the
.
) is entered from the input terminal.
, the output frequency can be adjusted in steps of 0.01Hz.
Jumping width 1 (
Jumping width 2 (
Jumping width 3 (
E6581531
(which changes the
)
)
)
6

Advertisement

Table of Contents
loading

Table of Contents