Toshiba TOSVERT VF-PS1 Instruction Manual page 17

High performance inverter
Hide thumbs Also See for TOSVERT VF-PS1:
Table of Contents

Advertisement

Operation panel
RUN lamp
EASY key [Note 1]
Lights when an ON
Press this key to control
command is issued but no
the function assigned
frequency signal is sent
with a parameter.
out. It blinks when
operation is started.
PRG lamp
Lights when the
inverter is in parameter
setting mode.
MON lamp
Lights when the inverter
is in monitor mode.
Blinks when the inverter
is placed in trip record
display mode.
RUN key lamp
Lights when the RUN
key is enabled.
RUN key
Pressing this key while
the RUN key lamp is lit
starts the operation.
Note 1: ⇒ For details EASY Key functions, refer to Section 5.22.
Note 2: When parameter
EASY key lamp
Lights when the EASY
key is enabled.
STOP key
Pressing this key while the
Serial RS485 connector/cover
RUN key lamp is lit
causes the motor to make
a deceleration stop. Press
2-wire RS485 connector. This
the key twice to reset the
connector is used to connect an
inverter after a trip.
optional device, such as an
extended control panel.
is set to
, the operation frequency cannot be set even if this lamp is lit.
Up key
A-5
E6581531
% lamp
Lights when the unit
is %.
Hz lamp
Lights when the unit is
Hz.
1
MODE key
Displays the operation
frequency, a
parameter, the cause
of a failure, and so on.
ENTER key
Up/Down key lamp
With these keys, you
can set the operation
frequency while the
Up/Down key lamp is
lit. [Note 2]
Down key

Advertisement

Table of Contents
loading

Table of Contents