Toshiba TOSVERT VF-PS1 Instruction Manual page 192

Communication parameters (4-wire RS485)
These parameters allow you to change the communication speed, parity, inverter number, communication error trip
timer setting, etc. from the operation panel or an external control device.
Title
Parity
(common to 2-wire RS485 and 4-wire
RS485)
Inverter number (common)
Communications time-out time
(common to 2-wire RS485 and 4-wire
RS485)
Communications time-out action *
(common to 2-wire RS485 and 4-wire
RS485)
Communication1 time-out condition selection
Frequency point selection
Point 1 setting
Point 1 frequency
Point 2 setting
Point 2 frequency
Communication speed (4-wire RS485)
Send waiting time (4-wire RS485)
Inverter-to-inverter communication setting
(4-wire RS485)
Protocol selection (4-wire RS485)
Block write data 1
Block write data 2
Function
Ditto
F-77
Adjustment range
:Non parity
:Even parity
:Odd parity
~
:OFF
~ sec.
2-wire 4-wire
Setting
RS485 RS485
No action No action
Alarm No action
Trip No action
No action Alarm
Alarm Alarm
Trip Alarm
No action Trip
Alarm Trip
Trip Trip
: Disconnection detection
: When communication mode
enable
: 1+ Driving operation
:Disabled
:2-wire RS485
:4-wire RS485
:Communication add option
~ %
~ Hz
~ %
~ Hz
:9600 bps, :19200 bps,
:38400 bps
:Default, ~ sec.
:Slave (issues a 0Hz command if
something goes wrong with the
master)
:Slave (continues operation if
something goes wrong with the
master)
:Slave (trips for emergency stop if
something goes wrong with the
master)
:Master (sends a frequency
command)
:Master (sends an output frequency)
: -
: -
:TOSHIBA
:MODBUS
:Disabled
:Command information 1
:Command information 2
:Frequency command
:Terminal board output data
:Communication analog output
:Rotational speed command
E6581531
Default setting
6
⇒
Refer to page
K-25