Toshiba TOSVERT VF-PS1 Instruction Manual page 189

Title
Communication1 time-out condition
selection
Frequency point selection
Point 1 setting
Point 1 frequency
Point 2 setting
Point 2 frequency
Block write data 1
Block write data 2
6
Block read data 1
Block read data 2
Block read data 3
Block read data 4
Block read data 5
Free notes
* : No action .. No action is taken even if a timeout occurs.
Alarm ........ An alarm goes off if a timeout occurs.
Trip ........... The inverter trips when a communication time-over occurs.
Note: Changes to the parameters
then on again.
Function
The message " " blinks at the left end of the operation panel.
The message " " blinks on the operation panel.
,
Adjustment range
: Disconnection detection
: When communication mode
enable
: 1+ Driving operation
:Disabled
:2-wire RS485
:4-wire RS485
:Communication add option
~ %
~ Hz
~ %
~ Hz
:Disabled
:Command information 1
:Command information 2
:Frequency command
:Terminal board output data
:Communication analog output
:Rotational speed command
Ditto
:Deselect
:Status information
:Output frequency
:Output current
:Output voltage
:Alarm information
:PID feedback value
:Input terminal board monitor
:Output terminal board monitor
:VI/II terminal board monitor
:RR/S4 terminal board monitor
:RX terminal board monitor
:Input voltage (DC detection)
:Speed feedback frequency
:Torque
:MY monitor 1
:MY monitor 2
:MY monitor 3
:MY monitor 4
:Free notes
: Rotational speed
Ditto
Ditto
Ditto
Ditto
~
and do not take effect until the power is turned off and
F-74
E6581531
Default setting
⇒ Refer to
page K-25.