Toshiba TOSVERT VF-PS1 Instruction Manual page 77

The functions assigned to the following control input terminals (contact input: ⇒ Refer to Section 7.2) are always
activated regardless of the settings of the command mode selection
1
• Reset terminal (default setting: RES, valid only for tripping)
• Power removal terminal (assigned to PWR by default)
• Emergency stop terminal
To make changes in the command mode selection
stop the inverter temporarily.
No change can be made to them if the inverter is in operation.
Preset speed operation
: Set this parameter at
: Any setting is valid.
1) Setting the run, stop and operation frequencies with the operation panel
Title
5
Power
supply
.
(terminal board).
Function
Command mode selection
Frequency setting mode
selection 1
R/L1 U/T1
S/L2 V/T2
T/L3 W/T3
F
Inverter
R
PWR
P24/PLC
CCA RX VI/II RR/S4 PP
and the frequency setting mode selection 1
Example of setting
Run/stop :Press the
(Operation
panel input)
To switch between forward run and reverse
(Operation
panel input) run, use the forward/reverse run selection
Speed command :Press the
Motor
IM
Shorted by a shorting bar when
shipped from the factory.
E-8
E6581531
and frequency setting mode selection
and
RUN STOP
on the operation panel
and
keys on the operation
panel to set the frequency.
To save the frequency, press
the ENTER key. Then,
and the set frequency are
displayed alternately for a
while.
first
keys
.