Toshiba TOSVERT VF-PS1 Instruction Manual page 199

Table of setting of contact input terminal function
Parameter setting
Positive Negative
logic logic
7
*1: Valid when
The frequency setting range is between =
time with respect to the frequency setting remains
deceleration is performed.
*2: If ,
function has a priority.
*3: After the motor slows down and comes to a full stop at a pre-excitation command, the motor is set free
momentarily to bring it into a pre-excitation state.
This function should not be used when
*4: Do not specify any number other than those listed in this table.
Sink logic/source logic
Switching between sink logic and source logic (input/output terminal logic) is possible.
⇒ For details, refer to the Section 2.3.2.
Function
No function is assigned
F: Forward run command
R: Reverse run command
ST: Standby
RES: Reset
S1: Preset speed 1
S2: Preset speed 2
S3: Preset speed 3
S4: Preset speed 4
Jog run
Emergency stop
DC braking
Acceleration/deceleration switching 1
V/f switching signal 1
PID control OFF selection
External thermal error
Communication priority cancel
HD operation retention
PID differentiation/integration clear
PID forward/reverse switching
Forced continuous operation
Specified speed operation
My function RUN signal
Auto-tuning signal
Integrating wattmeter display clear
(Frequency setting mode selection 1) is set at
(F: Forward run command) or
Parameter setting
Positive Negative
logic logic
~ (Upper limit frequency). The acceleration/deceleration
/ , unless switching between acceleration and
, (R: Reverse run command) is assigned at the same time, this
is set to or . Or the inverter might malfunction.
G-4
E6581531
Function
Trace back trigger signal
No function assigned
No function assigned
No function assigned
Binary data write
*1
Up/down frequency (up)
*1
Up/down frequency (down)
Up/down frequency (clear)
No function assigned
No function assigned
Forward/reverse selection
*3
Run/stop command
Commercial power/INV switching
Frequency reference priority
switching
VI/II terminal priority
Command terminal board priority
Permission of parameter editing
No function assigned
No function assigned
No function assigned
No function assigned
Rapidest deceleration command
*4
Preliminary excitation
No function assigned
No function assigned
(Up/down frequency).