(Odu,Enable,Config,Transmitter) Output; (Odu,Enable,Config,Transmitter) Hpa; (Odu,Enable,Config,Transmitter) State - Comtech EF Data CDM-550T Manual

CDM-550T Satellite Modem
KST-2000A FSK Remote Operation
1.2.7 (ODU,ENABLE, CONFIG,TRANSMITTER)
The user is prompted to edit the transmit attenuation. This is accomplished by
selecting the digit to be edited, using the [←] [→] keys. The value of the digit is
then changed using the [↑] [↓] keys. The user then presses <ENTER>.
1.2.8 (ODU,ENABLE,CONFIG,TRANSMITTER)
The user is prompted to select either ON, OFF, or WARM using the [←] [→]
keys, then press <ENTER>.
•
•
•
1.2.9 (ODU,ENABLE,CONFIG,TRANSMITTER)
1.2.10 (ODU, ENABLE,CONFIG,TRANSMITTER)
Note: If the HPA power is OFF, it cannot report errors, answer messages,
provide serial numbers, etc.
1.2.11 (ODU,ENABLE,CONFIG, TRANSMITTER)
The user may select from the options shown, using the [←] [→] keys, then press
<ENTER>.
MN/CDM550T.AA1
EDIT ODU TX ATTENUATION:
15.00 dB (PRESS ENTER)
SELECT KST TX OUTPUT:
OFF ON WARM (ENTER)
WARM is OFF, if COLD.
WARM is ON, if warm and NO FAULTS
FAULTS present, stays WARM and OFF indefinitely
CONFIG HPA: STATE
FAULT-LOGIC (ENTER)
SELECT KST HPA STATE:
ON OFF (PRESS ENTER)
SELECT HPA FAULT LOGIC:
SUMMARY NO-SUMM (ENTER)
ATTEN (Attenuation)
OUTPUT
HPA
STATE
FAULT-LOGIC
5
Revision 0
MN/CDM550T.AA1