Comtech EF Data CDM-550T Manual page 48

Front Panel Operation
(CONFIG, RX) DESCRAM (Descrambler)
(CONFIG, RX) CLK (Clocking)
6–18
SELECT RX DE-SCRAMBLING:
ON OFF (PRESS ENTER)
Select either ON or OFF, using the LEFT/RIGHT arrow keys, then press
ENTER.
When Transparent mode is selected, a V.35 descrambler is used. In Framed
mode, a frame-synchronised descrambler is used. It is recommended that
scrambling/descrambling be used at all times.
SELECT RX CLOCKING MODE:
BUFFER ON OFF(PRESS ENT)
Select either OFF or ON, using the LEFT/RIGHT arrow keys, then press
ENTER.
When OFF is selected, the Plesiochronous/Doppler buffer is disabled. The
receive clock will then be derived from the satellite signal, and will therefore be
subject to clock offsets relative to the local transmit clock, and a small amount (<
5%) clock jitter, due to the demodulation bit-timing recovery process at low
values of Eb/No.
When ON is selected, the Plesiochronous/Doppler buffer is enabled. The input to
the buffer will be the signal from the satellite, with any clock offsets and jitter.
The output from the buffer will be derived from the local TRANSMIT clock. In
this way, the receive data will be perfectly synchronous with this local clock. The
CDM-550T can be operated with independent transmit receive and transmit data
rates. Even in this configuration, where RX data rate <> TX data rate, the output
clock for the buffer will be phase locked to the transmit clock.
When the buffer is enabled, the size of the buffer may be selected using the menu
below:
CDM-550T Satellite Modem
Rev. 1.3