Comtech EF Data CDM-550T Manual page 132

Remote Control
Parameter Command
Type (InstructionC
ode and
qualifier)
Set Statistics SSI=
Sample Interval
Clear All Stored CAS=
Statistics
Retrieve next 5 N/A
unread Stored
Events
Retrieve Number N/A
of unread
Stored Events
15–18
Arguments for Description of arguments
Command or (note that all arguments are ASCII numeric codes, that is,
Response to ASCII codes between 48 and 57)
Query
1 byte, Command or Query.
numerical Used to set the sample interval for the Statistics Logging
Function.
SSI=x, where x = 0 to 9 in 10 minute steps. Note: setting this
parameter to 0 disables the statistics logging function.
Example: SSI=3 means 30 minutes
None Command only
Instructs the unit to clear all Stored Statistics
This command takes no arguments.
75 bytes Query only
Unit returns the oldest 5 Stored Events which have not yet
been read over the remote control. Reply format: {CR}Sub-
body{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-
body, where Sub-body=
ABCddmmyyhhmmss,
A being the fault/clear indicator.
F=Fault
C=Clear
I=Info
B being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Power on/off, or log cleared
and C being the fault code, as defined under the 'FLT' message
table entry, except Info codes, which are: 0=power off,
1=power on, 2=log cleared, 3=global config change, and 4=
redundancy config change. If there are no new events, the unit
replies with RNE? If there are less than 5 events to be
retrieved, the remaining positions are padded with zeros.
2 bytes, Query only.
numerical Unit returns the number of Stored Events which remain unread,
in the form xx. Note: This means unread over the remote
control - viewing the stored events from the front panel of the
modem does not affect this value. Example reply: NUE=98
CDM-550T Satellite Modem
Response to Command Query
(target to controller) (Instruction
Code and
qualifier)
SSI= (message ok) SSI?
SSI? (received ok,
but invalid arguments
found)
SSI* (message ok, but
not permitted in current
mode)
CAS= (message ok) N/A
N/A RNE?
N/A NUE?
Response to query
(target to controller)
SSI=x (see description
for details of argument)
N/A
RNE={CR}ABCddmm
yyhhmmss{CR}ABCdd
mmyyhhmmss{CR}AB
Cddmmyyhhmmss{CR
}ABCddmmyyhhmmss
{CR}ABCddmmyyhhm
mss
(see description for
details of arguments)
NUE=xx (see
description for details
of arguments)
Rev. 1.3