Comtech EF Data CDM-550T Manual page 53

CDM-550T Satellite Modem
(CONFIG, LOCAL)
(CONFIG, REMOTE)
Rev. 1.3
If LOCAL is selected then remote control will be disabled. Remote monitoring is
still possible.
If REMOTE is selected then the following sub-menus will be displayed:
If the unit has not been defined as an EDMAC SLAVE then:\
REMOTE CONTROL: BAUDRATE
INTERFACE
Select BAUDRATE or INTERFACE, using the LEFT/RIGHT arrow keys, then
press ENTER.
(CONFIG, REMOTE, BAUD)
If BAUD RATE is selected:
EDIT LOCAL BUS BAUDRATE:
19200 BAUD (PRESS ENTER)
Edit the baud rate of the remote control bus, connected locally to the M&C
computer. The value is changed using the UP/DOWN arrow keys. The user
should then press ENTER. Values of 300, 1200, 2400, 4800, 9600 and 19200
baud are possible.
Note that the asynchronous character format is FIXED at 8 data bits, 1 stop bit,
no parity (8-N-1).
Front Panel Operation
(PRESS ENTER)
6–23