Others - Kubota B2301 Workshop Manual

B2301, B2601, WSM
(Continued)

[11] OTHERS

5. Adding the LLC
a) Add only water if the mixture reduces in amount by
evaporation.
b) If there is a mixture leak, add the LLC of the same
manufacture and type in the same mixture percentage.
*Never add any long-life coolant of different manufacture.
(Different brands may have different additive components,
and the engine may fail to perform as specified.)
6. When the LLC is mixed, do not employ any radiator cleaning
agent. The LLC contains anticorrosive agent. If mixed with the
cleaning agent, sludge may build up, adversely affecting the
engine parts.
7. Kubota's genuine long-life coolant has a service life of 2 years.
Be sure to change the coolant every 2 years.
NOTE
• The above data represent industry standards that
necessitate a minimum glycol content in the concentrated
anti-freeze.
Replacing Radiator Hoses (Water Pipes)
• See page G-27.
Replacing Fuel Hoses
• See page G-25.
Replacing Intake Air Hoses
• See page G-27.
Bleeding Fuel System
Air must be removed:
1. When the fuel filter or lines are removed.
2. When the tank is completely empty.
3. After the tractor has not been used for a long period of time.
Bleeding procedure is as follows.
1. Fill the fuel tank with fuel.
2. Start the engine and run for about 30 seconds, and then stop
the engine.
Draining Clutch Housing Water
NOTE
• The tractor is equipped with a water drain plug (1) under the
clutch housing.
• After operating in rain, snow or tractor has been washed,
water may get into the clutch housing.
1. Remove the drain plug and drain the water, then install the plug
again.
(1) Water Drain Plug
G-33
GENERAL
9Y1211156GEG0047US0
9Y1211156GEG0048US0
9Y1211156GEG0049US0
9Y1211156GEG0050US0
9Y1211156GEG0052US0
9Y1211156GEG0053US0
KiSC issued 11, 2014 A