Initial Setup At The Control Panel; Installation Wizard; Using Installation Wizards; Setting The Measurement Units - Xerox WorkCentre 7800 series Administrator's Manual

Initial Setup

Initial Setup at the Control Panel

Installation Wizard

The Installation wizard starts the first time you turn on the printer. The wizard prompts you with a series
of questions to help you configure basic printer settings.
Note: You can complete the wizard at any time.
• To assign a static IP address or change the default dynamic addressing settings, use the IP Address
Settings wizard.
• To add phone numbers for support or supplies contacts, use the Contact Numbers wizard.
• To configure basic embedded fax settings, use the Fax Setup wizard.

Using Installation Wizards

At the printer control panel, press the Machine Status button, then touch the Tools tab.
1.
2. Touch Device Settings > Additional Install Options.
To start a wizard, touch IP Address Settings, Contact Numbers, or Fax Setup.
3.
4. Follow the onscreen instructions.

Setting the Measurement Units

At the printer control panel, press the Machine Status button, then touch the Tools tab.
1.
2. Touch Device Settings > General > Measurements.
3. To show dimensions in metric or imperial units, under Units, select an option.
4. To specify the decimal mark symbol that the printer uses, under Numeric Separator, select Comma
or Period.
5. Click OK.
®
22 Xerox WorkCentre
System Administrator Guide
®
7800/7800i Series Color Multifunction Printer