Creating A New Action - Xerox WorkCentre 7800 series Administrator's Manual
Color multifunction printer
Hide thumbs
Also See for WorkCentre 7800 series:
- User manual (304 pages) ,
- System administrator manual (258 pages) ,
- Quick reference manual (14 pages)
Table of Contents
Advertisement
Security
Creating a New Action
Click Actions at the top of the IPsec page.
1.
2.
Click Add New Action.
3.
On the Step 1 of 2 page, under IP Action Details, type in the Name. This field is required.
4.
In the Description field, type a description for the action, if desired.
5.
Under Keying Method, select Manual Keying or Internet Key Exchange (IKE).
Note:
Select Manual Keying if client devices are not configured for or do not support IKE.
If you selected IKE, under Pre-shared Key Passphrase, type the passphrase, then click Next.
6.
Configuring Manual Keying Settings
Manual Keying is used when client systems either do not support IKE or are not configured for IKE.
For IPsec Mode, select Transport Mode or Tunnel Mode.
1.
Transport mode only encrypts the IP payload, whereas Tunnel mode encrypts the IP header and the
IP payload. Tunnel mode provides protection for an entire IP packet by treating it as an
Authentication Header (AH), or Encapsulating Security Payload (ESP).
2.
If you selected Tunnel Mode, under Enable Security End Point Address, select the address type.
Options are Disabled, IPv4 Address, or IPv6 Address.
Under IPsec Security, select ESP, AH, or BOTH.
3.
4.
In the Security Parameter Index: IN field, type a 32-bit number larger than 256 that identifies the
inbound Security Association (SA).
5.
In the Security Parameter Index: OUT field, type a 32-bit number larger than 256 that identifies the
outbound Security Association (SA).
6.
If you selected ESP under IPsec security, under Hash, select an option.
Under Enter Keys as, select ASCII format or Hexadecimal number.
7.
8.
For Hash Key: IN and Hash Key: OUT, type a 20-character ASCII key or 40-character Hexadecimal
key.
9.
If you selected ESP or BOTH for the IPsec Security type, under Encryption, select an option.
Note:
If you are configuring an IPsec security policy to communicate with a Linux computer, and
you selected BOTH for the security type, select 3DES encryption. If you select AES encryption, the
data transfer rate is reduced.
10. For Encryption Key: IN and Encryption Key: OUT, type a 24-character ASCII key or 48-character
Hexadecimal key.
11. Click Save.
®
110
Xerox
WorkCentre
System Administrator Guide
®
7800/7800i Series Color Multifunction Printer
Advertisement
Table of Contents
