Electrical Specifications; 050 Series Gas And Steam Models - ALLIANCE CA050L Installation Operation & Maintenance

Electrical Requirements

Electrical Specifications

NOTE: Wire sizes were obtained from the
Canadian Electrical Code for 75 C. wire and are
intended for use as a guideline only. Electrical
connections should be made by a qualified
electrical contractor in accordance with all
applicable local and national requirements.
NOTE: Electrical specifications below are subject
to change without notice. Always refer to product
serial plate for most current specifications of
product being installed.

050 Series Gas and Steam Models

7
Serial Plate Rating
120V/60Hz/1ph
200-208V/60Hz/1ph
200-208-240V/60Hz/1ph
230-240V/50Hz/1ph
200-208/240V/60Hz/3ph
200V/50Hz/3ph
230-240V/50Hz/3ph
380V/50 or 60Hz/3ph
400-415V/50Hz/3ph
440V/60Hz/3ph
460-480V/60Hz/3ph
N/A = Not Applicable
48
Terminal Block
Connections
Required
L1, Neutral and ground
L1, Neutral and ground
L1, L2 and ground
L1, Neutral and ground
L1, L2, L3 and ground
L1, L2, L3 and ground
L1, L2, L3 and ground
L1, L2, L3 and ground
L1, L2, L3 and ground
L1, L2, L3 and ground
L1, L2, L3 and ground
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NOTE: Use copper conductors only.
NOTE: Connect to individual branch circuit.
NOTE: 3 Phase Only – Each tumble dryer must be
connected to its own individual branch circuit
breaker, not fuses, to avoid the possibility of "single
phasing" and causing premature failure of the
motor(s).
Serial Plate Amps
Nonreversing Reversing
9.3 N/A
5.1 N/A
5.1 N/A
6.3 6.9
2.8 4.0
3.3 4.2
3.1 4.3
1.6 2.0
1.6 2.0
1.4 1.9
1.4 1.9
Table 7
Recommended Circuit
Wire Size
Breaker
Rating AWG (mm
15A – 1 pole 14 (2.5)
10A – 1 pole 14 (2.5)
10A – 2 pole 14 (2.5)
15A – 1 pole 14 (2.5)
10A – 3 pole 14 (2.5)
10A – 3 pole 14 (2.5)
10A – 3 pole 14 (2.5)
10A – 3 pole 14 (2.5)
10A – 3 pole 14 (2.5)
10A – 3 pole 14 (2.5)
10A – 3 pole 14 (2.5)
70457901ENR7
2
)