Single Drop Control - ALLIANCE CA050L Installation Operation & Maintenance

Operating Instructions
Reversing Operation
Tumble Dryers with the reversing option prevent the
tangling of large pieces of laundry and minimize
wrinkling. These tumble dryers are equipped with a
second motor and additional controls which reverse
the rotation direction of the cylinder.
Reverse Control Switch
An "on-off" switch for manual timer models, or a
touch pad for OPL Micro models is placed in the
control panel area so the operator can select the
reversing or nonreversing operation. In nonreversing
mode, the cylinder will always turn clockwise (as
viewed from the front of the tumble dryer). If the
cylinder is turning counterclockwise when switched to
nonreversing, it will continue for a few seconds and
then start up in the proper direction.
IMPORTANT: After any electrical maintenance is
done, make sure that the blower motor is turning
clockwise as viewed from the front of the 050 and
075 series tumble dryers and counterclockwise on
the F75 tumble dryers. Then set the reverse control
switch to "nonreversing" and note that the cylinder
turns constantly clockwise as viewed from the front
of the tumble dryer. If not, interchange L1 and L2
service leads to the reverse drive motor.
62 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Single Drop Control

SD and SX Control Suffixes
1. Select HIGH, MED, LOW or NO HEAT by
turning the temperature knob.
HIGH Temperature 190°F (88°C)
MED Temperature 160°F (71°C)
LOW Temperature 130°F (54°C)
Figure 38
2. Insert the coin(s) in the coin slot.
Figure 39
3. Press START button to start tumble dryer.
Figure 40
IMPORTANT: To stop the tumble dryer at any
time during the cycle, OPEN DOOR. To restart the
tumble dryer, CLOSE door and press START
button.
4. When the cycle is complete, open door and
remove the laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
TMB2147N
25
C
TMB1492N
TMB2150N
W779
70457901ENR7