ALLIANCE CA050L Installation Operation & Maintenance page 27

4. Remove four front panel screws. Refer to
Figure 10. Keep door hinge cams in place on
door hinge lug. Pull lug and door assembly off as
one piece. Refer to Figure 11.
5. Remove remaining front panel screws. Refer to
Figure 10. Disconnect door switch harness from
switch. Take off front panel. Refer to Figure 11.
6. Exchange switch and plug locations. Depress
tabs with an adjustable pliers to remove plug and
switch from front panel. Reinstall switch,
orienting button toward center of machine.
Reinstall plug in switch's previous location.
Refer to Figure 11.
1
5
1 Plug
2 Switch
3 Side Screw
4 Door Hinge Lug
5 Door Assembly
Figure 11
70457901ENR7
3
2
4
TMB1995N
TMB1995N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
7. Reroute door switch harness up through top
panel, along underside of front flange, through
screw cable clamp, back down through top panel
and into upper left quadrant of cylinder
enclosure. Refer to Figure 12.
1
7
6
1 Screw Cable Clamp
2 Beginning Location of Door Switch Harness
3 Original Switch Location
4 Lint Panel Switch Harness
5 Wire Ties
6 Original Plug Location
7 Top Panel
Figure 12
8. Place front panel on machine, loosely attach four
bottom screws. Connect door switch harness to
switch in new location. Install door assembly and
four front panel side screws loosely. Refer to
Figure 13.
9. Check lint panel fit, adjusting front panel up or
down as required. Tighten four front panel side
screws to maintain position of front panel for
proper lint panel clearance.
10. Remove lint panel. Fully tighten bottom screws
on front panel.
11. Reinstall top screws and guide lugs.
Installation
2
5 3
4
TMB1996N
25