Unilinc Control - ALLIANCE CA050L Installation Operation & Maintenance

UniLinc Control

UO and RU Control Suffixes
1. Press the ( ) or ( ) keypad to change cycles. The
← →
center highlighted position is the selected cycle.
To customize a cycle, refer to the Programming
Manual.
2. Press START
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the
START pad must be pressed.
70457901ENR7
to start selected cycle.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Figure 48
3. When the cycle is complete, open door and
remove laundry.
To prevent the risk of fire, remove laundry
immediately in case of power failure.
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle is
complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
After an hour the machine enters delayed tumble
and will tumble for two minutes every hour for up
to 18 hours or until the door is opened.
Operating Instructions
TMB1276C
TMB1276C
WARNING
W779
69