To Reverse The Loading Door - ALLIANCE CA050L Installation Operation & Maintenance

Installation
3
2
1
1
1 Number of Shims for this Channel
2 Cylinder Head
3 Trunnion
4 Channel Identifier
5 Shims
6 Channel Location
7 Number of Shims for this Channel
Figure 9
10. Remove the motor(s) and motor bracket(s). Refer
to Figure 8.
11. Unbolt and remove the two vertical trunnion
channels.
12. Remove the junction/contactor box. Refer to
Figure 8.
13. Remove the exhaust thimble.
14. The gas supply line may require removal if it
extends past the rear panel. If so, disconnect the
union located between the gas and shutoff valves
and remove the assembly out through the front of
the tumble dryer.
15. Remove the tumble dryer from the crate base and
slide it through the door, sideways.
16. Refer to the appropriate service video,
installation manual and wiring diagram to
reassemble and install the tumble dryer correctly.
24
4
X
5
6
2
7
TMB2015K
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

To Reverse the Loading Door

The tumble dryer is delivered with a right hinged door,
but the door can be changed to a left hinged position.
1. Disconnect power supply to tumble dryer.
2. Unlock and remove control panel. Remove two
control assembly mounting screws from right
side. Swing open control to access upper flange
right guide lug assembly. Refer to Figure 10.
3. Remove lint panel.
IMPORTANT: Support door and hinge assembly
securely to prevent it from dropping once side
screws are removed from door hinge lug.
8
7
5
4
1 Control Assembly Mounting Screw
2 Control Assembly
3 Guide Lug Assembly
4 Side Screw
5 Screw
6 Lint Panel
7 Front Panel
8 Control Panel
Figure 10
1
2
3
4
5
6
TMB1994N
TMB1994N
70457901ENR7