Led Opl Control - ALLIANCE CA050L Installation Operation & Maintenance

Operating Instructions
U MODELS
PROGRAM REVERSING ENERGY
SAVER
BACK

LED OPL Control

EO and RE Control Suffixes
1. Press the Up ( ) or Down (
↑
cycles.
To customize a cycle, refer to the Programming
Manual.
2. Press START (
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the
START ( ) pad must be pressed.
68
S MODELS
PROGRAM REVERSING ENERGY HEATING
SAVER
STOP
START
BACK
TMB1345R
HEATING
STOP
START STOP
TMB1371R
TMB1371R
) keypad to change
↓
) to start selected cycle.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
H MODELS
PROGRAM REVERSING ENERGY
SAVER
BACK
TMB1345R
Y MODELS
START
BACK
TMB2370N
Figure 47
3. When the cycle is complete, open door and
remove laundry.
To prevent the risk of fire, remove laundry
immediately in case of power failure.
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle is
complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
After an hour the machine enters delayed tumble
and will tumble for two minutes every hour for up
to 18 hours or until the door is opened.
HEATING
STOP
START
TMB1346R
TMB1346R
C, D, AND I MODELS
ECO
WARNING
TMB1375R
W779
70457901ENR7