Configuring Rip On A Vlan - Avaya 8800 Configuration Manual

TriggeredUpdateEnable
AutoAggregateEnable
AdvertiseWhenDown
InPolicy
OutPolicy
Cost
HolddownTime
TimeOutInterval

Configuring RIP on a VLAN

Configure RIP on a VLAN so that the VLAN acts as a routed VLAN (a virtual router).
Prerequisites
• The VLAN is configured and has a spanning tree group (STG) assigned.
• An IP address is assigned to the VLAN.
• RIP is enabled globally.
Configuration — OSPF and RIP
Variable
Enables or disables triggered RIP updates. The default is
disabled.
Enables or disables RIP automatic aggregation. RIPv2
automatically aggregates routes to their natural mask.
Automatic aggregation can be enabled only in RIPv2 mode
or RIPv1 compatibility mode. The default is disable.
Enables or disables AdvertiseWhenDown. If true, the
network on this interface is advertised as up, even if the port
is down. The default is disable.
If you configure a port with no link and enable
AdvertiseWhenDown, the port does not advertise the route
until the port is active. Then the route is advertised even
when the link is down. To disable advertising based on link-
states, disable AdvertiseWhenDown.
Determines whether the RIP can learn a route on this
interface. It also specifies the parameters of the route when
it is added to the routing table.
Determines if a route is advertised from the routing table on
this interface. This policy also specifies the parameters of
the advertisement.
Indicates the RIP cost for this interface. The default is 1,
and the range is 1 to 15.
Configures the length of time that RIP continues to
advertise a network after determining it is unreachable. The
range is 0 to 360 seconds. The default is 120 seconds
Configures the RIP timeout interval in seconds. The range
is 15 to 259 200 seconds. The default is 180 seconds.
Configuring RIP on a VLAN
Value
June 2011 67