Avaya 8800 Configuration Manual page 147

9. In the Metric box, configure the OSPF route redistribution metric for basic
10. In the MetricType box, select a metric type.
11. In the Subnets box, select a subnet.
12. Click Insert.
13. Click Apply.
Variable definitions
Use the data in the following table to help you configure the OSPF redistribution parameters.
DstVrfId
Protocol
SrcVrfId
RouteSource
Enable
RoutePolicy
Metric
MetricType
Subnets
Configuration — OSPF and RIP
redistribution.
Variable
Specifies the destination VRF ID used in the
redistribution.
Specifies the protocol that is receiving the external routing
information.
Specifies the source VRF ID used in the redistribution.
Specifies the route source protocol for the redistribution
entry.
Enables (or disables) an OSPF redistribute entry for a
specified source type. The default is disable.
Configures the route policy (by name) that is used for
detailed redistribution of external routes from a specified
source into an OSPF domain.
Click the ellipsis (...) button and select from the list in the
Route Policy dialog box. To clear an entry, use the Alt key.
Configures the OSPF route redistribution metric for basic
redistribution. The value can be a range from 0 to 65535. If
configured as 0, the original cost of the route is used.
Configures the OSPF route redistribution metric type. The
default is Type 2.
The cost of a type 2 route is the external cost, regardless of
the interior cost. A type 1 cost is the sum of both the internal
and external costs.
Allows or suppresses external subnet route advertisements
when routes are redistributed into an OSPF domain. The
default is allow.
Configuring route redistribution to OSPF
Value
June 2011 147