Avaya 8800 Configuration Manual page 200

OSPF configuration using the ACLI
Prerequisites
• The Ethernet Routing Switch must have an IP address assigned.
• Enter OSPF Router Configuration mode.
Procedure steps
1. Configure the OSPF router ID IP address by entering the following command:
2. Configure the following parameters as required, or accept the default value:
3. Use the following variable definitions table to help you configure other global OSPF
4. To ensure that OSPF is configured correctly, use the following command:
5. Exit OSPF Router Configuration mode:
6. Enable OSPF for the switch by entering the following command:
Variable definitions
Use the data in the following table to help you use the OSPF Router Configuration mode global
OSPF commands.
200 Configuration — OSPF and RIP
router-id <A.B.C.D>
• as-boundary-router enable
• auto-vlink
• default-cost [{ethernet|fast-ethernet|gig-ethernet|ten-
gig-ethernet} <0-65535>]
• timers basic holddown <0-60> <seconds>
• rfc1583-compatibility enable
• trap enable
parameters as required.
show ip ospf [vrf <WORD 0-64>] [vrfids <0-255>]
exit
You return to Global Configuration mode.
router ospf enable
June 2011